Activating a joint

I think whoever thought up this idea was baked as hellz0r!:stoned:

And again and again... but i will explain again:

Heating lightly the weed for a reasonable amount of time (the recipes for activating weed say some minutes at the oven) WILL convert the THCa to THC, increasing the potency of the weed. Its plain chemistry.

But if you just light the joint and smoke it, the heat of the burning weed its TOO HOT, and burns some THC. Also, the time of heating is too short, so there is not time enought for the THCa to be completly transformed to THC.

Lip, Chisme, and all non-believers, why dont you try doing it before flaming? You have nothing to lose (at worst one joint), and everything to win (a wayyy higher high)...

Coelho is right btw...

Jah listen to Coelho, he actually has science on his side, not bullshit.

done it a couple of times and yeah it works

To Coehlo -

You understand the concept of heating the bud at the right temperature at the right time in order to ''activeate" the weed, or increase its potency. Maybe you can understand my question. If i perform the same steps in activating a bud, but use an already rolled joint, will it work?

so you put it on tinfoil for how long and wat temp now? could someone explain the process?

I've personally placed a pre (double) rolled jay in the microwave for about 30 seconds with the paper lightly moistened. The end result was a dry and potent ass joint. I got higher than I have ever been before in my life off of just a single one gram joint that was activated.:stoned::stoned::stoned:

Buuullll... Here is the PROPER way to smoke a joint...

1. Break up weed
2. Roll up joint
3. Light joint
4. Smoke joint

Pretty simple if you think about it. :smokin:

what the fuck, smoke it