i was having PH, but it stabilizxed just like they said it would. I still wanna add co2, but im trying to figure out how to maximize what i have first
Printable View
i was having PH, but it stabilizxed just like they said it would. I still wanna add co2, but im trying to figure out how to maximize what i have first
Dusto2k, Where are the original precut holes located in the hut for the 4" flanges? Do they come with some sort of preinstalled rim to screw the flanges in? I guess Ive just never installed flanges.
Just to get installing the 6" flange straight you just put the two sides of the flange on the tent wall, hold it there and screw the screws/bolts through the material and then cut out the middle. I noticed that the flanges are all double sided. Can you only use one side of it? Were the flanges you got at HD the same as the Flanges you can get from the hydro shops made for the hut? Peace
If you cant tell I havent ordered any of this shit yet so I havent seen any of it, hence all the questions. I just wanna get everything perfect the first time I order it. Peace
theres a precut hole on the bottom left side of the hut, and the top right corner for your exhaust. both are 4"
looking at the hut from the front. The intake will on the left wall about 12 fopot from the ground and about 3 inches from the front door. (down in the corner. The Exhaust is in the ceiling in the back right corner. And yes the flanges and hut are pre drilled and have rings to make install super easy.
when i bought the hut it didn't come with double flanges, i guess they figured that out a little late for my liking. The flanges i got a HD are cheap duct flanges, i can put up a pic.
actually if you look at the pic i posted above, the intake is at the base of the hut
exhaust is in the roof in the back right corner, 3 passive intake flaps on the left, back and right walls.