Pic 1- Here are all the supplies you need for this 4" carbon scrubber.
Printable View
Pic 1- Here are all the supplies you need for this 4" carbon scrubber.
First thing to build is the inner chamber.
pic1 - supplies:
6"-4" reducer
4" cap
2 - 4.5" screw fasteners
10" length of Heavy duty chicken wire
2 - pannyhose legs
pic2 - Wrap the 10" length of chicken wire around the 4" end cap to form a cylinder. I used a bunch of zip ties to secure the cylinder's shape.
Pic3 - Slide the pannyhose legs over the cylinder to act as a screen for the carbon.
Pic4 - Secure the end cap on one end of the cylinder with one of the 4.5" screw fasteners.
Pic5 - Secure the 6"-4" reducer to the open end of the cylinder with the other 4.5" screw fastener.
That's it. The inner chamber is done. Set aside we'll need it in a bit.
Next to build is the Outer Chamber.
Pic1-Supplies
6" cap
2 - 6.5" screw clamps/fasteners
12" length of Heavy duty chicken wire
3 - pannyhose legs
pic2 - Wrap the 12" length of chicken wire around the 6" end cap to form a cylinder. I used a bunch of zip ties to secure the cylinder's shape.
Pic3 - Slide the pannyhose legs over the cylinder to act as a screen for the carbon.
Pic4 - Now you should have all of these parts....almost done:thumbsup:
Pic5- Now slide the 6" cylinder over the 6" section of the 6"-4" reducer (and the inner chamber) and secure with a 6.5" screw fastener
Filling with Activated carbon and finishing it.
pic1 - Without the 6" end cap on the bottom, the filter should look like this....notice this space in between the chambers....this is where the activated carbon goes.
pic2 - I used an oil spout with the end cut off to more easily disperse the carbon into the filter.
pic3 - Here is the filter filled with carbon.
pic4 - Finally put the 6" end cap on the bottom and we're good to go.
Pic5 - Here is the finally product.
Have fun kiddies...post if you have a question:thumbsup: :smokin: