AWSOME DIY DOUBLE CHAMBER BONG

For this You will need
A) A 1.25 pt 20 oz plastic bottle of pop
B) 2 pen cases or other tubes
C) A smaller plastic bottle then the first one wth the opening good for the mouthpeice
D) Sticky tack/Green stuff (modelling shit its comes in like blue and yellow and you combined the colors and it becomes green then you can mold it on shit and in like an hour it air drys proubly be and a modeling store.)
E) A metal bowl shape object with a hole in the bottem/unscrewable pipe
F) Lighter
G) Tape packaging or duct
H) Water or mountain dew works well too
I) WEED or tabbaco

First take the cap of the soda bottle off. Put a lighter over it to make it melted but still in shape. This part is tricky and you will want to be next to a sink. Stick the pen case through the top at a slight angle. Get it as deep as possible. Then take your mettle bowl and something to hold it other then your bare hands and hold the lighter over it for a long period of time. To get it really hot. Next stick it into the pen case and then put under water. this will be your bowl. cover the area around the top with sticky tack to make it airtight. Next take the lighter to the smaller bottles bottem and stick the other pen case in like before. Then do the same to the upper side of the soda bottle and stick the other end of the pen into the side. Cover those to areas with alot of sticky tak to be sure its air tight. Take the tape and put it on the side of the smaller bottle around the larger bottle and to the other side of the smaller bottle. This will keep it on and create a tighter seal. Fill with water so it is waited enought to stand on its own. And there you go a great double chamber bong.
Any questions post them here ill get a pic soon.