Printable View
How do you put hash into a joint where you are? (with skunk you basically use a grinder) but im not sure about the different ways you can put it in with hash.
Where i am everyone burns it to soften it up then pinch it of and kind of sprinkle it into the joint.
Another good way i found was just to get the hash and use a cheese grator (the smallest part with the smallest holes) and grate all the hash up, it goes into dust!
Hard hash is good when sprinkling, but soft hash is much better.
Just roll it into a sausage and roll it up in paper
I usually press out it into a circle shape on the table and then run over it a few times with the lighter until it bubbles. Next I put the weed or tobacco or whatever I am mixing it with over the top of the hash and mix it up with my fingers...kind of grind it up tell it's an even consistency and then roll it up. :smokin:
Oh, and I usually put a little bit of powder hash on the table so the sticky hash doesn't stick to the table or my fingers so much. :stoned:
you talking about squidgy black?Quote:
Originally Posted by LIP
Any hash that you have to burn to crumble is shitty hash.
I usually only smoke hash in my bong, 9mm thick custom roor.
i like to use those little meth pipes to vaporize hash and kief. or, put hash in a tobacco cigarette, and go get high while @ work. mmmmmmm.
uh never tried to put soapbar into a joint, but with the sticky gooey shit, I just roll it out into a fine line n pack weed around it ten roll it up
I seen some people take a soft small piece hash and squash it with their thumb to give it a circular shape and take their lit joint or cigarette and press down with the burning part on the hash and just smoke it on the lit joint or cig lol. I would rather sprinkle my hash ontop of my weed when rolling it though.
Haven't smoked hash but a few times and it was allways in a pipe mixed with dirt weed. I've heard of people using toasted tobacco as filler when rolling with it, but can't say much for it as I've never tried it.