Making bong

I have this pipe from CVS, you know the weird tobacco ones, and I just use the one piece, not the stem, I only use the actual bowl part so it hits hard. I usually roll joints but I was wondering if I took that piece from the pipe, attached it to like a 2 liter or some chamber, and with a rush hole, could i get hits still, or would it be too hard to hit, like would I have to breath in much harder and shit. Sorry if this makes no since. Let me know. Oh and I would just open up the top of the bottle to take hits, so it would be like a regular bong, but with this front piece of the pipe as the bowl.

A bit of a confusing read but I got the jist of what your asking (I think, kinda stoned), but your idea could work i just wouldnt recommend it due to the fact of the plastic burning. you dont want to be smoking plastic, ugh! One thing you could do is make a Powerhitter (thats what i call them anyway). What you do is take a two litter bottle and make a carb hole somewhere in the middle. Then you take your bottle cap and make a hole large enough to fit either a 1/4'' tube or hollowed out pen into. Make sure you tube goes through the cap and into the bottle. To use it insert the joint or blunt into the tube end that will be inserted into the bottle.

Illustration:
____
[
-----[------/jjjjjjjjjjjjjjjjjjjjjjj~~~~~
-----[------\jjjjjjjjjjjjjjjjjjjjjjj~~~~~
[____

The Joint should be inside the bottle. Now squeeze the bottle but gently so that the joint does not fall inside the bottle. Make sure you cover the carb. After some time the joint will have burned down a bit and smoke will be full inside the bottle. Now doing this doesnt take as much time as it sounds, the smoke fills up fast in that bottle. To take a hit you can either take it from the carb or carfully unscrew the bottle cap and gently squeeze the bottle to the general vicinity of you mouth and breath in.

hope i was some help.

Happy Toking:rasta:

Ok, This works too. Get a 2 liter bottle, about a quarter - 2/3 of the way up the bottle make a hole and put a hollow pen/tube down there [make it permanent if you want] unscrew cap, fill with soem water, put mouthpiece of pipe to the tube and suck through top. I've often broke bong slides and supstituted my pipe as a slide like this [great last minute fix] and it hits damn fine [unless your piece sucks]. But I suggest something more sturdy than a 2 liter, as to they crunch inwards, if you take a lighter to the outside walls and heat them up, they constrict and toughen, thus preventing it from crushing in as much, just dont melt the bottle.