Is there any possible way to tighten joints after they have been rolled?
Printable View
Is there any possible way to tighten joints after they have been rolled?
tear em open and re-roll, of just pack more in the end if you can. Give it a little twist can help too.
Roll it inbetween computer paper
After you first roll the j if its to lose then you could twist it with your lips.(also meakes it burn longer.)
erm.. anymore??
Twist one end tight, hold the other end and shake it back and forth gently. Then just tare off the excess paper. Works for me at least.
Have a good one!:thumbsup:
was just about to say thatQuote:
Originally Posted by Psycho4Bud
there's an alternative to this...flatten one side COMPLETELY so all you see is paper, then hitting the 'flat' end over and over relatively hard... it'll pack it down better/evenly... but if you hit the loose end, it'll do just the opposite...
k, lick it a little bit all the way around, not rediculously wet, just to make it moist, and make sure every part of the joint is moist too, then put it in a dollar bill and roll it around...it works 70% of the time, everytime
if possible, i do this all the time, just either remove the roach (if you have one) or untist one end. then take a match and pack the weed further down into the already rolled tube. of course this will make it shorter, but i like it as it burns longer and more slowly, doesnt break or bend as easily, and overall feels more sturdy in your hand.