rolling joints...?

hey, I was wondering what's the best way to roll a joint? I know how to roll a philly, but I'm not sure how to roll joints?

It's not hard after a bit of practice. Get the paper, bend it down the middle, put in some fine grain bud, roll it, lick it a bit to hold it together, and smoke that J :rasta:

the best way that i've found is that if you roll a loose,shitty jointis to ge the joint really wet with your tongue and then take a dollar bill and roll it around in the bill for about 6 seconds.:rasta:

Some people roll straight flat ones, cones, and some people fuck up and put all the weed in the middle so it's all bunched up aahh

im an okay roller i get the job done... once uv sealed the paper around the weed .. alot of which will prob have fallen out of the ends of the paper make sure to twist one end then pinch that and pack as much weed into the other end as possible i like to use a pen or sumthin to make sure its a tight filled joint then twist the other end up or wte u want then spark that shit!!! peace

Is it just me, or do joints take much more weed that just smoking out of a bong or pipe?

Maybe it's just me because I have a low tollerance level (I only started smoking on a regular basis recently) but I never need to use as much as I've seen used in joints. At least I don't think I use that much per high anyways.


And I've heard bible pages can work well for rolling... is this true?

yea you need alot more weed in a joint than you'd need if u were using a pipe.

bible pages are thin enough, but they dont stick well.

o joints deff burn up more of your weed... to roll a good one it takes like a little less then a gram but idk depends ... which would pack prob 3 or 4 bowls ...

click the link in my sig its the joint rolers hand book

I roll my jays into a cone shape, it works so much better that way, the trick is to roll the paper with the weed in it back and forth as many times as you need to get it into the right shape then lick the paper to get it sticky and start from the bottom, make sure it's tight, then work your way up the cone sticking it together and making sure it's tight, then twist one end off and push a roachie in the other (i'm sure u can guess which end it goes in :p).