2 out of 12 clones are wilting and curling...HELP

What is your experience level? (first timer

Your Equipment:
.1) Type and wattage of lights. 400mh
.2) Distance from tops? about 2 1/2 feet
.3) Reflector type? batwing
.4) Is there a consistent fresh air supply? well a door is open
.5) Do you have an exhaust fan and a circulation fan? circ.
.6) What are the bulb wattages, kelvin ratings, and schedule? 400 6000k 18/6

Your medium:
.7) Specific brand and type of soil, (coco, peat based soilless...) and anything you've added to it. (vermiculite, perlite, worm castings...) FOX FARM OF with added perlite to bottom of container
.8) Size of container. 3 gallon bucket
.9) Did you use peat pucks (or similar) to root clones or germinate seedlings? rooting plugs

Your nutrients and water:
10) Source of water? (tap, bottled or filtered) What's it's ph before adjusting?tap
11) Method of checking water ph. (ph pen, test strips, aquarium test kit...) aquarium test kid
12) Method of adjusting water ph. (phosphoric acid, white vinegar, hydrated lime, PH Up...) didnt have to
13) Specific brand and N-P-K ratio for each bottle. List dosages (quantity per gallon) and current feeding schedule. haven't used nutes yet.
you watering between feedings, and how much per watering? every other day with tap water
15) Any additives or tea's? (Superthrive, CalMag, molasses, Mother's Earth...)no
16) Are your ph levels stable, or do they fluctuate?the water stays the same usually
17) What is your ingoing water's ph? ...your runoff ph? unknown
18) Do you foliar feed? If so, with what, how often, and at what time do you spray? they're clones so i sprayed 1 time when I first tranplanted them.
Your growroom:
19) Indoors or outdoors? indoors
20) What size of closet, room or hut? 5x5x5 mylar room
21) What are the temps and humidity levels while lights are on? 76-80 ...With lights off? 68-74
22) Have you seen signs of insects in the growroom? no

Your strain:
23) What strain are you growing? bc hash X blueberry cough
24) From seeds or clones? clones
25) Is this an autoflower strain? no




So I just gor the clones yesterday. I got 12, and 2 of them are the exact same looking. I put a raised up clear plastic bowl over the top of them to keep some humidity in, but I dont know what the problem is. It's pissing me off!

Im no expert but with new clones id put the light a lot higher for a week so they get hardened to it'.. then lower it down' or even lower it a little day by day over a week period till its about 60 70 cm away...

sounds like a humidity issue to me. If they are brand new clones then they likely dont have roots yet. They need no light for the first few days, nothing but water and finally high humidity. The easiest way to deal with this right here and now is to get some clear plastic cling wrap and wrap it loosely around the plants. I just stuck some 10" sticks into the outside of my pots, then clustered them together with 4 sticks on the outside edges of my cluster. Take the cling wrap and drape it across the top and along the sides, make a clear box that does not touch and allows for free movement of the leaves. That will trap more heat and humidity into the space around the leaves and should help to stand them back up. Within a couple days the stems should harden up some and the roots will start to develop. After a week you can remove the cover as humidity will be less of a factor at that point.

Only after they are standing again will they require light. Until then no light. Once they are standing you will want to move the light far away as possible and then gradually bring it closer over the next few days. Clones are very delicate and thus need very little light and water for the first week or so.