Printable View
hello there....i plan to make oil from the leaves and trimmings of my plants.....when it is done and ready, how is it more efficient to apply it on a good joint without wasting it?
i thought of adding it on the joint with a tooth pick drawing a line across the length of the joint or even merge the paper-skins on the liquid....any ideas?
thanx in advance :)
well i usualy just put the oil on the paper, then put the weed and finally roll the joint. i wont recommend to merge the joint, would waste a lot, and you dont need so much oil anyway to get high!!! have fun u lucky bitch.
P.S. u can always try bubble hasch, seems nice and smooth
hash oil - hunny oil + g of bomb in a blunt = stoned.
Best way I found was to put a tiny bit on the end of a knife (really tiny) then heat the knive up so the oil goes really viscose. Let the oil run down the knife then smar the whole lot onto some tobacco you have already lined up in a paper.
Be firm when applying, otherwise the tobacco will jus stick to the knife.
Putting the oil onto the paper doesn't work so well, or so I've found anway.
But oil is fucked up man, really good stuff.
dont put the oil on the out side of the spliff tho because u will lose more smoke i would smear some on the inside of the paper and put your herb on top of it. i knew a guy who used to dip the whole paper in oil but i dont know how efficient that is really
smoked some on some bong bowls today :D
usually just put a few drops on some bud in my bubbler. burns kind of harsh though.