Printable View
I have a small 3 gal bubbler with 20 clones in it. 19 of them are doing fine but one looks like it has white frosty mold on it. The site where it is might not be getting as much O2 as the rest of them but she's the only one that shows this characteristic.
Has this happened to anyone here? How can I make her better and get rid of the mold? I would post the pic I took but you can't really tell, resolution sucks.
Pull it, or the rest will follow quickly. Bleach all components of bubbler, ( well, not the pump) before re-use.
Pulled 'em. Found that the two closest also had very small signs of mold but still showed so had to pull them too. Decided to transplant the rest to FL instead of leaving in their for more time. Check the hydro thread to see what I'm up to.
increase your airflow, to prevent to conditions to allow moulds and mildews to get started
Damn, there goes your 100% success rate. :D
I've been watching your hydro thread and your clones' roots are looking really good. Too bad you had to lose a few. :(
Good luck with the rest of your grow! :thumbsup:
PC :smokin: