New glass water bong!

Well, I drilled the bottle last night... stem hole about 1" up, and carb on the bottle's taper (its an Arizona Ice Tea bottle).

I then inserted a flex straw into the stem hole, and sealed the joint with clay. Cut the straw so that I could mount my bowl piece just below the neck of the bottle, after bending the flex part of the straw 90 degrees.

For the bowl, I used my old glass pipe that I dropped a few weeks ago. ground down the busted neck of the pipe to fit on the side of the bottle, inserted straw stem into the bottom of the bowl/bottle joint. Clayed it all in place, and cleaned the bowl real good first....

haven't toked yet, but took a couple hits of air... percolates real nice. I'm looking forward to smoking. Just wish I coulda found a metal or glass (or even acrylic) stem instead of this plastic straw... I'll have to keep an eye out...

haha thats sweet dude, way to make use of ur busted pipe

good job dude

Yeah, too bad I broke the bowl part already.