Broken bong Slide... any advice?

[SmokeyPotter]

After a recent smoking session, I looked at my bong slide only to see a crack along the circumference. When I put minimum pressure on it.... :eek: SHIT IT CRACKED IN HALF!!! :eek:

check it out:
Broken Slide (http://students.n.csbsju.edu/nebrady/images/brokenslide-001.jpg)

Do any of you have any advice on how I could repair this( besides the obvious "Buy another" ..i'd rather that be my last resort)
I tried crazy glue, but after it dried, I could pull it apart easily.

Thanks guys

[Day Dreamin Faze]

Not sure but there may be some special glue for glass may want to try that,ask at your local headshop.Epoxy?Crazy Clue?Super Glue?Buy A new one?

good luck

[BlastedTOtheSKY]

i would just go buy a new one there not that expensive

[JoeyL518]

if your looking to just ghetto rig it

take some gum and wrap it around it and let that dry

for sure there will be no air coming through

[CANADIANHERB]

i wouldnt waste my time tryin to fix it id'e buy a new one they're under 20$$ so it's not a huge deal, also if u use glue it might make nasty fumes once the bowl is heated.,

peace

[roll it up]

just make sure it is together as tight as can be,and tape it around the outside.it will look fucking retarded,but if will work.and since the tape is on the outside,it wont brun or create any nasty fumes.i had to do the same thing with a brand new 60$ glass bowl i just bought.i was smoking,and noticed a crack,and lightly touched it,and cracked right in half.jus like wut happened to ur stem