Log in

View Full Version : How to turn my individual pots into scrog grows?



Dr. VanNostrin
03-06-2006, 06:51 PM
Ok I have several of these 4-gallon pots 12-1/2" across 11" high. Any suggestions on how i can do a scrog setup for the individual pot? I plan on doing somewhat of a perpetual cycle, so I figure individual scrog pots would work better than just one big screen. I just dont know how to approach it from a design point-of-view, so I could use some adivice/suggestions/tips

thanks

jamstigator
03-13-2006, 01:39 PM
Here's how I did it: metal rods clipped from clothes hangars duct taped to the pot, forming the support struts for the screen. The screen itself I made by using wire cutters on a closet organizer wireframe drawer thingy from Home Depot. This does, I think, work better than just one big screen, because when you need to do maintenance you can just remove one pot at a time and the screen (being attached to the pot itself) comes right along.

crazydudee
05-05-2006, 09:00 PM
any pictures?

busteruk7
05-06-2006, 01:37 AM
Here's how I did it: metal rods clipped from clothes hangars duct taped to the pot, forming the support struts for the screen. The screen itself I made by using wire cutters on a closet organizer wireframe drawer thingy from Home Depot. This does, I think, work better than just one big screen, because when you need to do maintenance you can just remove one pot at a time and the screen (being attached to the pot itself) comes right along.
i have recently chatting with my m8 about doing this for my next grow and we came to the same conclusion of using metel coat hangers anyway i will set this up for my next grow and let ya all know how it goes
cheers all :)