Please help out guys

[tkmk4204eva]

so i have absolutly no money so i wanted to make a vaporizer what are items tht u need and how to u do it to make a vaproizer

[Green Screen]

First off, get a lightbulb and cut off all the metal stuff towards the bottom, and get all the electronics and shit out. You need two straws (or just cut a smaller piece off a big one) and stick them both part of the way in and now you need to make a seal across the hole. the longer straw will be the tube you suck through, the short one you keep your finger over as the carb. grind up your weed as best you can and put it in there, then hold a lighter under and move it around so your shit wont start burning. thats pretty much hit.

[DiLoS]

I do the same thing as green screen accept, I don't cut all the metal off part off, I only down maybe own thread on the metal part, this is so that I can screw a bottle cap on the top and don't have to have the hassle of taping shit all up. I try to break the glass internals on the inside with the knife take all the internals out, and then give it a good wash, I think this is importent so you don't inhale stuff left from the gases that are still left on the inside of the lightbulb because I didn't and my heart was racing like I had just did a 100m dash and I think not washing it out credited to that. I then put 2 holes in the bottle cap, one is going to be where you put your straw in, the other will be another straw for your carb. I then taped part of the bulb so I could hold it easily while letting it eat up with out burning the tips of my fingers. Now you put your dope in the light bulb, screw on the cap and put your straws in the cap, grab the light bulb by the taped part (that's pretty obvious :P ), and get a fire source to heat the bulb, I prefer a candle. Wait a little bit and then you'll start seeing smoke come from the dope. Once the bulb has filled up with a good amount of smoke, inhale that bad boy and enjoy. You'll want to have a surface to put the light bulb on because it's pretty bloody hot.

I like using clear lightbulbs instead of the coated ones because you can see how much smoke you have and I don't trust inhaling the coating on those coated ones.

[50BagOfGreens]

thats some damn good advice. im going to make one now. thx man

[420purplehaze420]

dont put the lighter right on the bulb just swirl it under it, dont put a lot of herb in or ur just wasting it

[passit420]

u can wash the inside out of croated(foggy shit right) with water.