glass question...

[Derby]

hey everyone, my glass bubbler has taken critical damage and the mouth piece on it snapped off, would it be A: possible to heat up each end of the pieces and fuse them back together B: buy a rod of pyrex and attempt to melt a line of glass around the break to connect it all back or C: please help with what to do.

Thank you very much

BObb.

[Leftover Crack]

glass melts anywhere from 500 °C (900 °F)- 1650°C (3180 °F) so you'll need a really powerful torch to fuse them together.

[DrGonzo]

is the mouthpiece (where it is broken0 part of the main body of the bong? or is it a seperate piece, sealed with a rubber o-ring? cause it'll be pretty hard to repair a break on the main body of the bong...you'll never be able to melt the glass back together without shattering the bong in your hands. 2-part epoxy is your best bet...but clean it up real good, and let it air for a few days. glue fumes aren't the best thing for your brain cells...

[ndhawk]

You could maybe try masking tape. My glass bowl broke into two pieces right in the middle, and putting tape around it, it still gets me good and high.

[weedfean]

mabe with a blow torch or you can duck tape it back togather duck tape fixes everything

[HvyFuel]

Not to mention the way it enhances the aesthetics of the piece.

[anycraic]

yes indeed nothing like a nice coloured glass pipe with a load of filthy duct tape wound around it

[311junkie]

they do have that new clear duct tape from 3M. .... you really cant salvage a broken bong without it looking like shit. break down and buy a new one if you really care that much about asthetics. and hey.... be more careful next time man, glass bongs aint cheap

[weedfean]

may be if you just buy a new one

[david420]

duct tape!!!!!!!!!!

[smokey]

use a hammer :D lol then buy a new one heheheh

[david420]

LOL hammer..