Help with bubble cloner

[johnnyrocketfuel]

I just built a bubble cloner out of an air pump, small rubbermaid container...... and need some help with running it.

1. How much air pressure should I run through the 2-10" bubble wands.
2. What should I set the water level to.
3. Do I run the pump 24/7 or have it cycle on a timer?

The cloner is made out of a 6qt rubber maid contain, it is pretty small. About 13" Long, 8" Wide & 7" Deep.

Any help would be appricated.

JRF

[fhydro]

I made the same bubbler for clones. So :
enough pression with an air stone to wet the lid, so the roots with the bubbles, the cubes must not touch the water.
i put an EC of 0.6 so 300 ppm.
air 24/7
and it works!!
When the roots are 5 cm, it's better to separate them before hurting the roots.
Fhydro

[fhydro]

I forgot, for 5 liters buckets with 3 liters inside, i think that 60 l/h is a minimum.
Fhydro

[johnnyrocketfuel]

Thanks for the help, I really appricate it.

JRF