emilya
01-11-2011, 09:19 PM
After looking at many of the available inline filters available out there I decided that this probably was not rocket science, and I took on the challenge. I wanted a cheap design that could be adjusted later if necessary to provide more or less protection.
So I had another excuse to go to that Hunky Man Meat Market that we all know of as Lowe's. Soon I came home with the following:
30"x50" of chicken wire, cut in half
3 activated carbon smell reduction furnace filters (the most expensive item)
1 4" duct inlet
1 plastic trash can
1 roll of duct tape
I liked the idea of using a trash can in order to slow down the air flow a bit with an expansion chamber so the charcoal could work better. I am not sure yet if the 3 carbon filters in this design will be enough to scrub the air coming out of my fan. More carbon is on the way to me, but I thought it would be good to try a first attempt with simply what was available at Lowe's today.
First I cut a slit at the bottom to allow the cleansed air to escape below a final scrub area. The outlet hole is below this wire layer. If I need a bit more scrubbing with this design I will pour a pure carbon layer out onto a fiber filter at this level with the chicken wire supporting it. For now, the chicken wire simply supports the final furnace filter level.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6930-diy-carbon-air-filter-003.jpg
For now, I am not ducting to the attic. Therefore, instead of putting an outlet duct at the far end of the filter, I simply cut a hole for the scrubbed air to exit the system.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6929-diy-carbon-air-filter-002.jpg
I used the remaining chicken wire to force an air layer between the final filter and the upper filters.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6921-diy-carbon-air-filter-004.jpg
I folded two more complete filters into the remaining space and taped up the can after putting the inlet duct in the lid. Made sure it was well sealed to ensure air flow through the system.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6922-diy-carbon-air-filter-005.jpg
Hooked up to the fan and tested.
Conclusions:
I could not believe the difference in here in the first 15 minutes. I decided that I was just used to the fragrance and that I should leave for a while so I could come back and smell the house after I came back home. When I walked in the door 2 hours later, I could not believe how fresh and clean it smelled. No trace of the previous problem could be discerned. I can have friends over again! :thumbsup:
Emmie
So I had another excuse to go to that Hunky Man Meat Market that we all know of as Lowe's. Soon I came home with the following:
30"x50" of chicken wire, cut in half
3 activated carbon smell reduction furnace filters (the most expensive item)
1 4" duct inlet
1 plastic trash can
1 roll of duct tape
I liked the idea of using a trash can in order to slow down the air flow a bit with an expansion chamber so the charcoal could work better. I am not sure yet if the 3 carbon filters in this design will be enough to scrub the air coming out of my fan. More carbon is on the way to me, but I thought it would be good to try a first attempt with simply what was available at Lowe's today.
First I cut a slit at the bottom to allow the cleansed air to escape below a final scrub area. The outlet hole is below this wire layer. If I need a bit more scrubbing with this design I will pour a pure carbon layer out onto a fiber filter at this level with the chicken wire supporting it. For now, the chicken wire simply supports the final furnace filter level.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6930-diy-carbon-air-filter-003.jpg
For now, I am not ducting to the attic. Therefore, instead of putting an outlet duct at the far end of the filter, I simply cut a hole for the scrubbed air to exit the system.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6929-diy-carbon-air-filter-002.jpg
I used the remaining chicken wire to force an air layer between the final filter and the upper filters.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6921-diy-carbon-air-filter-004.jpg
I folded two more complete filters into the remaining space and taped up the can after putting the inlet duct in the lid. Made sure it was well sealed to ensure air flow through the system.
http://boards.cannabis.com/members/emilya-albums-emmie-s-trash-can-carbon-air-filter-10min-30-picture6922-diy-carbon-air-filter-005.jpg
Hooked up to the fan and tested.
Conclusions:
I could not believe the difference in here in the first 15 minutes. I decided that I was just used to the fragrance and that I should leave for a while so I could come back and smell the house after I came back home. When I walked in the door 2 hours later, I could not believe how fresh and clean it smelled. No trace of the previous problem could be discerned. I can have friends over again! :thumbsup:
Emmie