Bong Troubles...

[mike420mike]

Yeah, I'm new here.
Yeah I'm sure there are probably many posts on this, but I've searched all over and can't find anything helpful.
My bong has a big hole in it, I've got a picture...
http://img212.imageshack.us/img212/8793/123bongtj4.jpg

Any way to fix it?
= [

I mean, for a temp fix I wrapped plastic wrap around the hole, which works to some extent, but then I have to just use it like a bowl, w/o water = [

[DaBudhaStank]

That picture makes it kinda hard to see the actual hole, due to all the paint shop work, but i'm guessing the hole is roughly the size of a nickle or so? If it's in the base of the bong where the water goes, you should be totally safe using some water resistant modeling glue, or super glue or gorilla glue, whatever you fancy. Should be able to patch it back up with the missing piece(s) if you still have them. It would take some time and patience, but well worth it. If you DONT have the missing parts however, all I can think to do is find some sort of water proof material, stick it over the hole and tape it or glue it there. You could try taking it to a shop and see if they do repairs, but you'd need to leave your slide at home and clean it out thoroughly.

[twitch]

take a piece of duct tape and put it there thats the best bet

[Bond]

the hole looks a decent size so it would take a bit of careful work. If you have the missing pieces id try to stick em on good enough with modeling glue as DaBudhaStank was saying."shoe glue" works great aswell although it stinks like heavy chemicals and should let sit for a couple days.

Another method is to use the cocking that is used for showers or bathtubs. I dunno maybe do it with just cocking or mix it up with both. apply the glue to the pieces first let set then go overtop with the cocking.Try to make it clean or just blob it on to seal it. you may not get it looking perfect but aslong as its sealed.

[smok3y]

Buy a new bong..:jointsmile:

Unless you have the missing part to glue back inn, there aint really much you can do aprt from tape it up with water proof duct tape or try a find another bit plastic to fit in there and glue that inn..:jointsmile:

[mike420mike]

alright, thanks a lot guys!
and the paint work was to try to outline the hole a little more, apparently that backfired. lol.
we'll I'll do my best to fix it. Otherwise it's just an excuse to buy a bigger, better one!:jointsmile: