Glass Glue??

[redsunknight]

So I got this triple-perc bong (named The Scientist) from Hempstalk in September, and not too long ago I dropped some weed on the ground, got up, and knocked the bong over onto concrete, Which broke the neck off. (thats the second time I have gotten up and knocked a bong over onto concrete)

Surprisingly it broke off fairly cleanly, with only a few small chips missing. So it got me wondering, whats the best type of glue (if there is any) that I could get to repair my bong?

[Smurph]

Epoxy. I use it often to create water tight bonds. It dries clear, costs about $2 a tube at nearly any store. Comes in two separate tubes, you squirt both out, mix em together and apply it. Let it set for at least an hour or two before use. Make sure not to put any epoxy on anything that will get hot (like a bowl). You don't want to be heating this up while smoking. So long as it isn't near the bowl it'll be ok.

[phatmax666]

Epoxy might do it !

[redsunknight]

Sweet thanks I'll try that

[highsox]

I usually use silicone for my bowls when they break..but I don't know about entire bongs, epoxy should work though