Mending a glass pipe...

[worm]

I have a glass pipe that was dropped and the bowl cleanly broke off of the stem of the pipe. Is there a safe way to repair this into a working condition?

[Nutzilla]

I used krazy glue on my ash catcher when it broke and haven't had a problem with it, as long as you aren't heating the glue itself it shouldn't matter.

[worm]

i was going to use krazy glue until i saw all the "toxic fumes, don't enhale" warnings all over it...

[Adolf Smittler]

i used rubber cement on mine. it had a nice clean break as well. just wait til it's dried all the way and be sure to get the flame in the bowl and there shouldn't be a problem. also it will probably break in that same spot every time from now on (mine did)

[affasd]

my friends ash catcher also broke and glue worked fine, but thats casue that part wont get hot at all. personally i wouldnt risk it since it would be so close to where your heating and it could heat up and release fumes, especially if its a smaller pipe

[worm]

What about a glue gun?

[nft]

your asking for shitty fumes if you use a glue gun

[brad1028]

aquarium glue has worked good for me in the past , i know they sell it at home depot..

[Metaphor]

only true love and imagination can fix a bowl my dude.

[BatCountry]

awgh man.

[ldg420]

As hard as it may be, it is time to put the piece to rest and replace it with an new one.....:stoned:

[smokies delight]

try a hot glue gun first i used it on my bong it worked ok but my shit was fucked, try man before u ditch the one one, unless u have the oppertunity than hell ya juss buy a new one

[420derf]

I have repaired three glass bubblers with J-B Weld epoxy.
The pipes are stronger than new after repair.