neox
11-12-2007, 04:04 AM
supplies:
1: a stainless steel water valve (5/8" O.D. x 3/8" Angle Ball Valve)
2: 3/8" Drive Spark Plug Socket - 5/8"
3: electrical tape
4: screen
5: weed
6: four way screw driver
Steps:
1: take the nut off of the water valve
2: get a 4 way screw driver and remove the knob that turns at the end (put screw back in is optional)
3: place socket inside the wide end of the water valve
4: take electrical tape and tape the socket securely and air tight to the water valve (i used half a roll secureing the socket)
5: place screen at the end where the nut was
6: place weed inside and smoke it up
(you can also use an adhesive to bind the socket and water valve together but i wouldnt recomend this because if u get it inside the valve u may end up smoking it *not a pleasant taste*)
1: a stainless steel water valve (5/8" O.D. x 3/8" Angle Ball Valve)
2: 3/8" Drive Spark Plug Socket - 5/8"
3: electrical tape
4: screen
5: weed
6: four way screw driver
Steps:
1: take the nut off of the water valve
2: get a 4 way screw driver and remove the knob that turns at the end (put screw back in is optional)
3: place socket inside the wide end of the water valve
4: take electrical tape and tape the socket securely and air tight to the water valve (i used half a roll secureing the socket)
5: place screen at the end where the nut was
6: place weed inside and smoke it up
(you can also use an adhesive to bind the socket and water valve together but i wouldnt recomend this because if u get it inside the valve u may end up smoking it *not a pleasant taste*)