A little help with a waterfall bong

[make it legal]

Ok so i basically know how to make a waterfall bong, but last time i tried it, I wasn't sure how to get the bowl in the cap and keep it airtight. What should I use to make it airtight. Last time I tried there was like no suction bringing the flame into the bowl when they water was pouring out because the air was coming on the sid of the bowl.

[make it legal]

Ok so i basically know how to make a waterfall bong, but last time i tried it, I wasn't sure how to get the bowl in the cap and keep it airtight. What should I use to make it airtight. Last time I tried there was like no suction bringing the flame into the bowl when they water was pouring out because the air was coming on the sid of the bowl.

[Blitzed]

make a hole slightly smaller then the bowl peice, then just get it really hot, and stick it through. Also when I was younger id use lil tinny pieces of gum to go around the edge.. Idk if that is possibly bad for you.. but Im still alive

[Jadian21]

Is that a different term for a Gravity bong? Sounds like what you're describing I'm just not sure if the terminology is different where you're from or if you're talking about a whole different thing.

[make it legal]

No, but they use the same type of bowl-on-cap-of-bottle system.

Thanks, I'm gonna try using gum.

[Blitzed]

Similar concept except a waterfall has a hole at the bottem, where the water goes out pulling the smoke down with the suction.

[Jadian21]

Ahh I see, well yeah Blitzed covered it the way I'd do it. Small hole, heat it up, and slip the bowl piece in through forming a seal. Hot glue works too if absolutely needed.

[make it legal]

Yeah I would do that but I don't want it to be permanent. It's just the bowl part of my metal piece and I still want to use that too.

[Blitzed]

http://www.everyonedoesit.co.uk/img/cannabis_information/bongs/bongs_diagrams_waterfall.jpg

There is a nice lil diagram

[Jadian21]

Haha, I like how it says inhale, but what the hell kind of lighter is that?

[make it legal]

You've never seen those? I think they're called clickers or something like that. You can pull out the wheel and it makes a great rod for packing joints.

[mfqr]

Be careful about burning plastic. If you inhale those fumes, it can degrade your high. Plus it's very unhealthy.

[invoke]

If it's part of a metal pipe it probably screws on right? Well yeah make the hole a little smaller and start to screw it into the cap and it'll put treads into the cap and you can unscrew it anytime.